Troubleshooting - Wagan Tech iOnBoost V8 Torque Manual De Usuario

TROUBLESHOOTING

Jumpstart Warning Lights
The iOnBoost is ready to jumpstart when the cables are connected and a steady green light
illuminates on the cable safety block. The following chart displays the combinations of warning
lights that occur when the iOnBoost fails to display the ready light:
Warning lights Type of warning
Flashing red No vehicle battery detected
and green
Cables are not making a
lights
good connection
Vehicle battery voltage too
high for jumpstarting
Solid red and 90-second timer has
green lights expired; the smart cable
has shut down
Solid red light iOnBoost charge is too low
for jumpstarting
(no green)
Solid red light Short-circuit
with beep
(no green)
Solid red light Reverse polarity
with pulsing
beep
(no green)
Solid red light Reverse charge
with slow beep
(no green)
Solid red light Over-heating
with fast beep
(no green)
Wagan Tech and wagan.com are trademarks of Wagan Corporation.
User's Manual—Read before using this equipment
©2019 Wagan Corporation. All Rights Reserved.
Solution
Check cable connection.
Check terminals for corrosion.
Check with a mechanic for other starting
related issues.
Disconnect cables from both the battery and
the iOnBoost and follow connection procedure
again.
The iOnBoost needs to be recharged.
Disconnect immediately and follow proper
connection procedure again.
Disconnect immediately and follow proper
connection procedure again.
Disconnect the iOnBoost from the vehicle
battery immediately.
Disconnect and allow unit to cool for 10
minutes.
7