Initial Operation; Intended Purpose - Deuba 100674 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

INSTRUCTIONS
General
ATTENTION! Observe the safety and assembly instructions in order to avoid
the risk of injury or damaging the product.
Only for domestic use and not for commercial use!
Important: Read these instructions carefully and thoroughly. Keep these
instructions to read through at a later date. If you give the product to anyone
else at some point in the future, please ensure you also pass on this manual.
Keep small parts out of the reach of children. Pay attention especially when
unpacking it. Keep plastic bags and other packaging away from children
reach. Danger of Suffocation!
Check the delivery for completeness. Later complaints cannot be accepted.
Check all elements and parts for damages. Despite careful checks since may
happen that even the best product takes damage during the transport. In
this case, do not build up of your product. Defective parts can endanger your
health.
Never modify the product! Changes will void the warranty and the product
may be unsafe or even dangerous.
For cleaning use a sponge and warm soapy water. Do not use solvent based-
cleaners or detergents for example Bleach those can damage the product.
Unpack all the parts and elements of the set and place the components on
the top of the carton or other clean surface. This protects your new product.
This protects your new product.
Please also pay attention not toscratch the floor while working with tools.
Make sure that this product is fully assembled before use, as shown on the
illustration.
GB
www.Deuba24online.de
8

Initial Operation

Connect the connecting piece (3) to the pressure washer spray gun (7).
Turn it by 90°C until it engages (bayonet joint).
If necessary, connect the enclosed adapt¬er (6) to the spray gun before
installing the connecting piece (3) from the pipe cleaning hose.
Switch on the pressure washer and squeeze the trigger on the spray gun (B
7)
Whilst the nozzle head (4) is moving through the pipe cleaning hose (2)
manually.
To release blockages, squeeze the trigger several times in a row then
release it.

Intended purpose

The pipe cleaning set clears blockages from pipes,down pipes,drains and
toilets.
The equipment is suitable for the following pipes:
Curve C no more than 90°.
Diameter D at least 40 mm.
Radius R at least 70mm.
The operator or user is responsible for accidents or damages to other people
or their property. The manufacturer is not liable for damages caused by use
other than for the intended purpose or improper operation.
Übersicht
1 Pipe cleaning set
2 Pipe cleaning hose
3 Connecting piece
4 Nozzle head
5 Scale
6 Adapter
7 Pressure washer jet gun (sold separately)
9
www.Deuba24online.de

Publicidad

Tabla de contenido
loading

Tabla de contenido