Electrical Voltage - SSS Siedle CMC 612-02 Guia Del Usuario

English
Application
Camera module 80° for video sur-
veillance, system-free. For mounting
in Siedle Vario 611 housing.
Integrated heating with thermostat,
infrared lighting and electronic con-
trol circuit. Video signal transmission
via coaxial cable 75 Ohm.

Electrical voltage

Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
In the case of video systems, the fol-
lowing mounting situation must be
avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Scope of supply
• Camera module CMC 612-...
• Terminal block
• Allen key size 2.5
• This product information
Mounting
1 Recommended mounting height
appr. 1.60 m to centre camera.
For information on mounting the
camera module, see the "Vario
mounting instructions" enclosed
with mounting frame MR 611-...
2 Note the mounting position of the
camera, the type designation must
be legible at the top back of the
module.
3 Pick-up angle of the camera
with an angle of aperture of 80°.
The angle of vision of the camera
module can be pre-adjusted hori-
zontally and vertically by around 30°
depending on the mounting situ-
ation.
4 On the back of the camera,
release the centrally positioned
screw by screwing the Allen key one
turn to the left. Position the camera
eye using the Allen key to the
required viewing direction.
5 Fix the camera eye in the required
position by turning the screw. Do
not fasten the screw too tightly.
Terminal assignment
+M Supply voltage
-M Video 20–30 V DC
Vc Actuation from the door
- loudspeaker to turn the
camera on
VKA Actuation of camera
distributor –M is switched
A1 Potential-free contact
A1 for additional applications
b Power supply 12 V AC
c for heating
Coaxial cable
L conductor
S shield
Pilfer safeguard
In order to protect the Vario modules
from unauthorized access, the pilfer
safeguard controller DSC 602-... can
be optionally used in conjunction
with the ZDS 601-... This can be
used to protect the inserted modules
from unauthorized access.
Servicing
6 Exchange of an existing camera
module (CMC 611-...) for a
CMC 612-... The installation only
needs to be performed at the door
station.
The terminals "–" and Vcs must be
bridged to terminals "–" and Vcs at
the TLM 612-...
Specifications
Suitable for continuous operation
Colour system: PAL
Image pick-up: CMOS sensor 1/3"
720 x 480 pixel (horizontal/vertical)
Automatic day/night switchover
Lens attachment: 2.9 mm
Aperture angle: horizontal appr. 80°,
vertical appr. 60°.
Mechanical adjustment range:
Additional by appr. 30° on the hori-
zontal and vertical
Resolution: horizontal 500 TV-lines
Integrated lighting: infrared
Video output: 1 Vss to 75 Ohm
2-stage heating: 12 V AC
max. 130 mA
Operating voltage: 20–30 V DC
Operating current: max. 105 mA
Protection system: IP 54, IK 10
Ambient temperature:
–20 °C to +55 °C
Height of structure (mm): 32
Dimensions (mm) W x H x D:
99 x 99 x 58
CMC 612-12 USA
Colour system: NTSC
For further technical details, see
above
5