Publicidad
3
Scotchlok
IMPORTANT NOTICE: Before using this product, you must evaluate it and
determine if it is suitable for your intended application. You assume all risks and
liability associated with such use.
Warranty; Limited Remedy; Limited Liability.
This product will be free from defects in material and manufacture at the time of
purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT
LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. If this product is defective within the warranty
period stated above, your exclusive remedy shall be, at 3M's option, to replace
or repair the 3M product or refund the purchase price of the 3M product.
Except where prohibited by law, 3M will not be liable for any indirect,
special, incidental or consequential loss or damage arising from this 3M
product, regardless of the legal theory asserted.
3M and Scotchlok are trademarks of 3M Company.
Used under license in Canada.
3M et Scotchlok sont des marques de commerce de 3M.
Utilisée sous licence au Canada.
3M Electrical Markets Division
3M, Austin, TX 78726-9000/
3M Canada, London, Ont. N6A 4T1/
3M Mexico S.A. de C.V. Av. Sta Fe No. 55
Colonia Sta Fe C.P. 01210 Mexico D.F.
Made in U.S.A.
Fabriqué aux É.U.
Hecho en E.U.A.
www.3M.com/electrtical
78-8126-6673-9
560N
™
540H
Wire Connector
54007 09513
0
2
WARNING/MISE EN GARDE/ADVERTENCIA
Turn power off before installing or removing terminal or
connector. All work should be done according to
appropriate electrical codes.
Coupez le courant avant d'Installer ou de retirer des bomes
ou des connecteurs. Toute manipulation doit ´ltre effectuèe
selon les codes d'electricitè appropriès.
Desconecte la energía eléctrica antes de instalar o quitar
una terminal o conector. Todo el trabajo debe hacerse de
acuerdo con los códigos eléctricos apropiados.
Installation Instructions
Instructions d'intallation
Instrucciones de instalación
Use only with insulated copper wire. Do not strip insulation.
Recommended Tool: 9" lineman's pliers or slip-joint pliers.
Á utiliser uniquement avec un fil en cuivre isolé. Ne pas
dénuder la gaine isolante. Outil recommandé: pince de
monteur de lignes de 9 po ou tenaille à articulation à glissière.
Usar solamente con conductor de cobre aislado. No retirar el
forro del conductor. Herramienta recomendada: pinza de 9" o
pinza ajustable.
Double Run Connections
Doubles connexions de fils continus
Tender la conexión doble
Publicidad
