Oxford OX281 Instrucciones De Uso página 3

GB
FRONT PADDOCK STAND for use on motorcycles with 17" wheel rims
he
Important: -
1. The front stand must be used in conjunction with a rear stand - it is a two man operation
to safely raise and lower the motorcycle using these stands. The rear stand must have lifted
the motorcycle BEFORE the front stand is fitted and make sure the motorcycle is stable and
t
secure.
Do
2. THE STAND IS ONLY TO BE USED ON A FIRM, SMOOTH AND LEVEL SURFACE.
3. This stand is not ideal for all motorcycles, especially where the brake caliper extends from the
lower part of the front fork (radial brakes)
Note: - before lifting the motorcycle it may be necessary to remove the front mudguard to allow
the front wheel to be removed and also if necessary loosen the wheel spindle fixings.
Designed to suit fork leg overall widths of 26cm (10 ¼") or less. Not suitable for small diameter
fork legs or those without flat fork bases.
Check there are no obstructions at the rear of the fork legs that prevent the rear pin(B) assuming
the normal lifting position (i.e. brake caliper casting or speedo drive.)
One lifting pin(A) should be placed underneath the motorcycle front fork and the other pin(B)
resting behind the fork (the side facing to the rear of the motorcycle).
Push down on the handle and raise the front wheel off the ground. The over-centre action will
pull the handle to the ground. Re-check the pin location and the stability of the motorcycle on
both stands.
Do not leave the machine unattended with the front end raised off the ground.
Do not turn the handlebars while the machine is on the stand otherwise the bike may fall off the
stand.
Handle
tube
Spare Codes
OF822F
Pin (A) Pin (B)
Pin (A)
Pin (B)
Front Stand Lifting Forks (Pair)
Lifting
arms
Upright tube
For Bobbin Fitting Chart visit:
www.oxprod.com/bobbins or
scan QR code
3
GB