Installation - BKS B 1956 Manual De Instalación

Installation instructions
B 1956 / B 1959
Motor-driven lock for narrow stile profiles
24
4.2

Installation

• Fully insert the plug of the connecting cable into the socket on the underside of the lock.
• Introduce the lock at an angle from above into the lock recess. In doing so feed the cable into the
profile (see fig. 4).
• Be careful not to buckle or strain the cable. Do not pull the cable taut!
• Attach the lock at the designated fixing points on the profile using the two countersunk head
screws provided. If other screws are used, be careful not to exceed the maximum screw length of
18 mm. Otherwise the screws will strike against the lock case.
• To complete the installation, put the lock in standby mode by sending a signal to the signal input.
Fig� 4: installation
EN
B 9000 1046 9-43501-01-0-8
B 1990 3XXX
B-19900
24
24
10.2016 | 19651S | Printed in Germany
B 1956 /
B 1959