Eldom planet WRK1100 Manual De Instrucciones página 9

pic. 1
HOW TO USE
- before starting the device, make sure that all the components are properly installed
- connect the device to the mains – the display (4) will show "00.00"
- to start the food processor use the selector switch (2). To choose one of 8 different speeds of operation change the position of
the selector switch (2).
- the device is equipped with the "slow start" function – it reaches the desired speed after a few seconds.
- during work, the display shows the time of operation. To reset the time set the selector switch (2) in position "0"
- to activate pulsed operation turn the selector switch (2) in position "P".Releasing the selector switch automatically returns it
to position "0".
- the ingredients may be added both before mounting the bowl on the base, and during the operation of the device via the
opening in the cover (12)
NOTE:
Choose the speed adequate for the type of the attachment fig. 2
The speed should be also adjusted to the consistency of the processed ingredients.
After use carry out the following:
- set the selector switch (2) in position "0" and wait until the attachment stops moving
- remove the cover (12)
- swing out the base arm (5) by pressing the lock button (3)
Exercise caution when opening the base arm (5). It is recommended to hold it from top so as not to open it too rapidly
- remove the attachment by turning it right
- unlock the bowl (6) by turning it left and remove it from the base (1)
NOTE
The device will not start if the base arm (5) is not lowered and locked.
The device will also not start if the selector switch (2) is not set to "0" when the arm (5) is being lowered. To start the
device in this case, after releasing the arm, turn the selector switch (2) to "0", and then select the speed.
If the base arm (5) is raised during the operation, the device will stop. To resume the operation of the device, lower the
arm (5), turn the selector switch (2) to "0", and then select the speed.
AUTOMATIC COUNTDOWN
This function allows you to set the time after which the food processor will automatically stop operation.
- this function can be activated only when the device is connected to the mains, and the selector switch (2) is set to "0"
- use the "+" and "-" buttons located below the display (4) to set the time in 10 second intervals
- the maximum setting is 10:00 min
- after starting the device with the selector switch (2), the display (4) will show the elapsed time every 1 second
- rotating the selector switch (2) to "0" turns the device off and freezes the countdown. The countdown will be continued after
resuming operation
- to disable this function set the selector switch (2) to "0" and press the buttons '+' and '-' simultaneously. The display (4) will
show '00:00'.
NOTE
Do not exceed the maximum time of continuous operation of the device. Any failure to comply with the above, as well as any
failure to keep the device idle for the required time may irreparably damage the engine and render the warranty void.
If the device blocks during operation, before cleaning, disconnect it from the mains and wait until the attachment stops moving.
If the device slows down during mixing or whisking, stop the operation and thin the mixed or whisked product. To prevent the
ingredients from flowing out of the bowl during mixing, do not fill the bowl above 2/3 of its volume.
Place the device on a flat, hard and stable surface.
pic. 2
•
EN 9