Waldbeck Halley Manual Del Usuario página 72

EN
72
Connections
• Connect the receiver power jack to AC power with the power adapter
(included), the Power LED (Figure 13) will be illuminated.
• The WIFI LED (Figure 13) will flash rapidly indicating that WIFI has not
been connected to any router before.
• Now you should open your mobile device to install WS TOOL to connect
the router and receiver.
• The WIFI LED will be flashed when success to connect the WIFI and
illuminated when success to connect the web server.
• The LED flash slowly indicating that the device connect to router but the
signal is not good,now you need to check the network or re-configure.
• Place the sensor array and indoor thermo-hygrometer transmitter about
1 to 3 meter from the receiver and wait several minutes for the remote
sensors to synchronize with the receiver.
• Once synchronized, the Indoor blue LED (Figure 13) and Outdoor blue
LED (Figure 13) will be illuminated. The LED flash slowly indicating that
there is no data updated to receiver,you should re-set the receiver or
sensors
• The RF LED (Figure 13) will be flashed several times indicating that the RF
signal is received,if no flashed mean that no RF signal,you should re-set or
re-power the receiver or sensor.