Eldom croper MG10N Manual De Instrucciones página 9

HAIR CLIPPING
- Make sure the appliance is clean, correctly assembled and oiled.
- Before clipping the hair, comb it to make it more natural.
- Install the right comb head (5) by sliding it in the side slideways of the cutting head (phot. 2).
To remove the comb head, press the "PUSH" area on the comb head and move it according
to the indicated direction.
The rotating ring (2) allows for precise control of hair length: 0.8 mm - 2 mm. Additional comb
heads (5) of 3 mm, 6 mm, 9 mm and 12 mm, and the 5-grade control ring offer 25 different
hair lenghts.
- It is recommended to start clipping with the use of the comb head for longer hair.
- Clip small areas by moving the appliance slowly through the hair.
- Start clipping from the neck upwards or from the forehead and the temple upwards.
- Hold the appliance gently under the hair, so that the comb heads are pointed upwards and
lie flat on the head.
- Without using the comb heads, the hair can be clipped evenly to the length of 0.8-2 mm.
Do not use the appliance for clipping wet hair.
phot. 2
CLEANING AND MAINTENANCE
After using the appliance, the chamber of cutting knives should always be cleaned. For this
purpose, open the cutting head (1) by pressing the clipper blades with your thumb in the
direction shown in phot. 3. Protect the blades against falling down.
NOTICE
Before opening the cutting head, turn the hair length control ring (2) to position "2 mm".
Clean the blades with the brush included in the set.
Cutting blades must be maintained on a regular basis. Put one to two drops of oil between
the blades and turn the appliance on for a few seconds.
Do not use hair oils, fat, oils mixed with refined kerosene or other solvents.
Do not immerse the appliance in water. Before cleaning, unplug the appliance and turn it off.
Do not use any cleansing agents which are strong or may damage the surface.
Wipe the casing with a moist or dry cloth.
The cutting blades are wear parts and should
be maintained on a regular basis.
The are not covered by the guarantee.
phot. 3
9