Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation for Eyewash
NOTE: Close water supply lines BEFORE connecting the hose assembly.
Step 1: Mount hose
1. Connect the pipe nipple and the pipe tee to the eyewash valve as shown in Figure 1.
• Apply pipe sealant (supplied by installer) to all pipe joints.
• Use strap wrench around yellow pipes to prevent marring.
2. Mount the hose clip to the wall (fastener supplied by installer).
Step 2: Connect water supply
1. Connect 1/2" IPS water supply piping to the pipe tee.
2. Open the water supply line and check for leaks and adequate water flow.
Figure 1
Bradley Corporation • 215-868 Rev. H; ECN 07-526
1/2" IPS
Supply Inlet
Pipe
Nipple
Eyewash
Valve
Spray
Hose
Wall
Bracket
Tee
8/22/07
S19-430EH
3
Publicidad
Tabla de contenido
