Battery Removal - Waterpik CC-01 Manual Del Usuario

1. 2.
Mo de
Cle an
Wh iten
Mas sag e
CHA RGE
1.
2.
3.
CARE OF YOUR WATERPIK
DISPOSAL AND BATTERY REMOVAL
Cleaning
1. After each use, turn off unit, remove the brush head from the handle
and rinse brush head under running water.
2. Wipe the handle dry after each use.
Disposal
This product contains rechargeable Nickel Metal Hydride batteries. The
batteries are not replaceable.
Please do not dispose of the unit in the household waste. Remove the
batteries per the instructions below and recycle at your local recycling
center.

Battery Removal

Note: This process is not reversible
Remove the battery only at the end of the product's life for recycling. Doing
so earlier will destroy the product. Deplete the battery charge until the
brush no longer operates. Observe basic safety precautions.
Remove the batteries as shown and recycle them and the rest of the product
according to local regulations.
1. Use a screwdriver to remove the screw and battery door.
2. Hold the handle upside down, press the toothbrush shaft, and release
the two tabs inside the handle using a flathead screwdriver to release
the internal components of the handle.
3. Insert screwdriver next to the battery connections, and push out of
plastic covering. Twist and break the battery connections. Remove the
circuit board and pry the battery from the circuit carrier.
4. Recycle or dispose of the battery properly.
TOOTHBRUSH /
®
13