Wattio DOOR Manual Del Usuario página 14

Press on the flap as shown, to open the protection cover and place the batteries respecting
their polarity as shown below.
Get close to the area where the DOOR will be places and switch it on, pressing the B2.
The indicator will flash red once, then green
five times, and after few seconds, six more
times red showing that it has been correctly
connected.
If it does not flash following the correct
sequence, verify that the GATE is switched
on and that the signal requirements are
respected.
If it does not work, reset the sensor
pressing both buttons together (look at the
reset section below) and switch the device
on again.
Stick both elements on a smooth and clean surface. The distance between the sensor
elements must be under 2cm when the door/window is closed.
14