Warning Indicators; Environmental Protection - Eldom WK280S Manual De Instrucciones

"ZERO" OR "TARE" FUNCTION
To weigh different loads consecutively without removing loads from the scale.
Put first Load on the scale, get weight reading. Press [ZERO] button to reset the LCD
reading to "0" before adding next load. You can repeat this operation.
BATERIE
AUTO SHUT OFF

WARNING INDICATORS

CLEANING
1. DO NOT immerse the scale in water.
2. Clean with soft moist cloth without detergents, wipe dry

ENVIRONMENTAL PROTECTION

- the appliance is made of materials which can be recycled,
- it should be handed over to the applicable collection point for the recycling
of electrical and electronic equipment
1. "ZERO" function
When total sum of all loads on scale ≤ 4% of scale's max weight capacity
(4% = 200g when capacity is 5 kg).
LCD will show "_ _ _" lub "0g" each time [ZERO] button is pressed.
"_ _ _" means not stable, please wait for a moment.
"0g" and meanwhile an icon "o" on lower left corner of LCD mean "ZERO"
function is active. Max weight capacity remains unchanged.
2. When total sum of all loads on scale > 4% of scale's max weight
capacity. (4% = 200g when capacity is 5 kg).
LCD will show "_ _ _" lub "0g" each time [ZERO] button is pressed.
"_ _ _" means not stable, please wait for a moment.
"0g" and meanwhile an icon "TARE" on lower left corner of LCD mean
"TARE" function is active.
Max weight capacity is reduced by total weight of all loads.
By pressing [ZERO] you can see the total weight of all loads on the scale.
If you want to weight more loads, just press [ZERO] to reset LCD reading to
„0" again.
Auto shut-off occurs if display shows '0' or shows the same weight reading for
2 minutes. To maximize battery life, always press ON/OFF again to turn off the
scale after using.
- when display shows „0" press [ON/OFF] to turn off the scale.
- when display shows weihgt reading, press [ON/OFF] for 3 seconds
to turn off the scale.
1. Replace new battery
2. Scale overload. Remove item to avoid damage.
8