System Connection - Avtech AVM503 Manual Del Usuario

 PREVIEW WITH CCTV TESTER MONITOR
FOR SELECTED MODELS ONLY
This camera support composite output for you to preview the viewing angle if it's correct or not while
installing camera. Find the receptacle housing of a RCY connector in the camera, and get a suitable plug
to connect to a CCTV tester monitor.
Please follow the specifications as below to purchase the suitable plug.
 Specification of contact
11
15.8
1.8 2
1.7 2
 Overview of optional plug cable
Connect to a RCA cable
DDD
 SYSTEM CONNECTION
1. Connect IP cameras and a monitor to the NVR, and power on the NVR, as illustrated below.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
Type1
 Specification of housing
Receptacle housing (for pin contact) Plug (for socket contact)
9.5
3.2
19
 CABLE OVERVIEW
Cable
Power cable DC12V power supply.
RJ45 network cable* Connect it to a RJ45 cable.
GND Ground wire
Reserved for external alarm
Alarm-in**
device connection
Reserved for external alarm
Alarm-out**
device connection
Remove the insulating coating of
wire, and twist it with a ground
RESET
wire together to reset default
4.3
13 camera
Colored as blue, used to
Line-in** connect to a microphone for
audio input.
Colored as green, used to
Line-out** connect to a speaker for audio
output.
* For PoE (IEEE802.3af) installation, make sure your network
cable has the maximum cable resistance of 20Ω, such as
CAT.5e or CAT.6 cables, to conform to the standard of
IEEE802.3af.
** For selected models only
2. Wait till each camera is configured automatically and you will see camera images on the monitor
soon.
Note:
Local connection only allows monitoring locally. To monitor from anywhere other than the NVR is installed,
please connect your NVR to Internet.
Type2
 DEFAULT VALUES
Description
IP address
Port number
User name
Password
It's strongly recommended to change the default
user name and password before using the
camera to keep your account safe.
To change the default account, log into the
camera, and go to Config.  General 
Account. Create a new account, and remove
the default one.
192.168.1.10
88
admin
admin
m542_543_quick_V1.5