Optional Accessories - Avtech AVM503 Manual Del Usuario

 CAMERA INSTALLATION
TYPE1

 Standard package
Installation
Guide
Camera Instructions CD manual
a
TYPE2

 Standard package
Installation
Guide
Camera Instructions CD manual
 Optional accessories
Waterproof accessory kit
a
Step1: Separate the dome cover from the camera.
Step2: Make sure the screw holes on the plate are aligned with the holes on the camera base. If not, slightly loosen the two screws on the plate
and rotate it.
Note: A file for its installation sticker could be downloaded from www.surveillance-download.com/user/a_installation_sticker.pdf.
Step3: Mark the locations of the two screw holes on the ceiling or wall, and drill a hole for each on the ceiling or wall. The distance between
your camera and the location you want to monitor should be 3 ~ 4 meters.
Step4: Fix the camera to the ceiling or wall with the supplied screws.
Step5: Connect your camera to power.
Step6: Pan, tilt and rotate the lens itself to adjust the position and viewing angle of the camera, and fasten the two screws on the plate to fix.
Note: You don't need to manually pan the type with motorized pan.
Step7: Replace the dome cover back to the camera.
Screws &
wall plugs
Note: Please wipe the inner part of the dome cover against the lens for clear images.
Step1: Uncover the dome camera by loosening the screws on the housing with the supplied wrench (Figure 1).
Step2: Check your desired viewing angle of the camera. According to the viewing angle and the instruction of the installation sticker, paste the
sticker up in an appropriate position on the wall or ceiling.
Step3: Follow the instruction printed on the sticker as the Figure 2 to drill the three holes.
Step4: Locate the three holes on the camera as Figure 3. They are where the three supplied screws belong.
Screws &
wall plugs
Step5: Screw the camera in place and power up your camera
Step6: Check the viewing angle on a CCTV test monitor.
Step7: Adjust the viewing angle of the camera again, if necessary.
Step8: Replace the dome cover in a proper position, adjust the transparent dome cover for not to cover the lens, align the hole on the dome
cover to in order not to have water leakage as Figure 3 and have the three screws on it tightened.
Note: For clear images, please clear of fingerprints the inner part of the dome cover against the lens.
Note: In order not to affect waterproof, do not have the lines near the lens pressed while replacing the transparent dome cover.
To check the complete user manual and free PC CMS software (CMS Lite),
please scan the QR code or go to
Figure 1 Figur e 2
www.surveillance-download.com/user/m521.swf
Figure 3
738z