Important - Accessory Power ENHANCE PowerUP Manual Del Usuario

EN EN
Wireless Mouse Operating Instructions
IMPORTANT: The PowerUP mouse must be fully charged
before its first use.
Place the mouse on the wireless charging zone to charge.
Adjust its position on the charging zone until the mouse's
LED indicator slowly blinks Red to indicate charging. When
over 90% (fully) charged, the mouse's LED will turn green.
To charge using a Micro USB cable, locate the included
USB cable labeled for use with the mouse. With the mouse
turned Off, plug the Micro USB cable into the mouse and
then into the computer to begin charging. The mouse can
be used as a wired mouse while charging.
Insert the included wireless USB receiver into your
computer's USB port. For best wireless performance, plug
the USB wireless receiver into a port on the front of
your computer.
The drivers will automatically install.
Allow up to two minutes for driver installation.
The mouse is now ready for use.
12