Eldom puri PO200 Manual De Instrucciones página 11

INSTALLATION
- The appliance must be set vertical on a flat surface, in a dry and spatial area.
- The room should be ventilated.
- At least 20 cm of free space should be left around the appliance.
- Connect the appliance to the power supply compatible with the parameters stated above.
OPERATION
All changes in settings are confirmed with audio signal. The purifier has an integral blockade, with which
the appliance may be activated only if the cap (3) is properly set. The appliance should be activated with the
POWER (F) button.
Operating modes
The selected mode of operation and the activated functions are indicated with the corresponding check lamps
in the control panel (2).
The AUTO MOde
("D" check lamp): the default mode of operation of the appliance, activated after switching it
on. In this mode, the appliance analyses quality of air and determines the fan speed automatically. The available
functions may be manually switched on and off: ionisation (B), UV lamp (E) and TIMER (J). This mode may be
also activated with the button (D).
The MAnUAL cOnTrOL MOde
and turns on or off the accessed functions: ionisation (B), UV lamp (E) and TIMER (J). This mode may be also
activated with the button (I).
The nighT MOde (the check lamp "C"): in this mode, the fan runs at the slowest speed only, and all active
control lamps go off. The available functions may be switched on and off: ionisation (B), UV lamp (E) and
TIMER (J).
Functions
TiMer
(the check lamp "J"): after turning the appliance on and selecting the mode of operation, the timer
may be set with the TIMER (J) button. This function allows to set the time after which the purifier will be
automatically switched off. Only full hours may be set, in the range from 1 to 8. Activation of the function is
indicated with the indicating lamp "J".
iOnisATiOn
(the check lamp "B"): the function supporting the filters in elimination of air pollution. The
function is activated and deactivated with the button (B).
The UV LAMp
(the check lamp "E") – the function supporting the filters in the elimination of airborne germs.
The function is activated and deactivated with the button (E).
FILTER REPLACEMENT
To achieve the highest capacity, the filter should be replaced at least every 6 months.
- the condition of the filter is indicated with the control lamp "H" in the control panel,
- the filter should be replaced when the check lamp "A" in the control panel goes on,
- to replace the filter, switch off the appliance and disconnect it from the mains.
- open the cover (3) – Fig. 3,
- remove the filter by pulling 2 strips – Fig. 3,
- install a new filter – Fig. 3,
- install the cover, making sure that all catches in the cover (3) match the corresponding seats in the body.
The purifier has an integral blockade, with which the appliance may be activated only if the cap (3)
is properly set.
- finally hold the button "A" in the control panel for 5 seconds to reset the control lamps.
in this mode, the user decides about the speed of fan with the button (I)
EN 11