Problems And Solutions - Lanaform SANRIO Hello Kitty HK-HQ601C Manual De Instrucciones

To clean the transducer:
1) Place 2 to 5 drops of vinegar on the surface and leave for 2 to 5 minutes.
2) Brush the build-up from the surface using a soft brush. Do not use a hard tool to scrape the surface.
3) Rinse the transducer in clean water.
4) Do not use soap or any other alkaline substances to clean the transducer.
To clean the basin unit:
1) Clean the water basin using a soft cloth and vinegar if there is build-up OR calcium deposits inside.
2) If the build-up is covering the safety switch, place a few drops of vinegar on it and clean using the brush.
3) Rinse the basin in clean water.
Storage:
1) Carefully clean and dry the ultrasound humidifier, following the maintenance instructions.
2) Leave to dry completely before storing it away. Do not store away when there is water in the base.
3) Store the appliance in a cool dry place, out of reach of children.
To clean the filter:
a) The demineralising effect and longevity of your filter depends on the mineral content of the water used in the
humidifier. We would like to remind you that it is recommendable to use distilled or demineralised water.
b) Make sure to rinse the filter in clean water every 2 days. To do this, remove it from the tank cap.

PROBLEMS AND SOLUTIONS

In the event of malfunctioning under normal conditions of use, please refer to the following table:
PROBLEM
Fan not working, no mist
Wind, but no mist
Strange mist smell
Too little intensity
POSSIBLE CAUSES
No electric current
Main switch closed
The water level in the tank is too low
Leak in the water tank
No water in the tank
The water level indicator is not in the
right position
The temperature of the unit is too low Put the unit in a room at ambient
Water has been stagnating too long
in the tank
Too much water in the groove
Mist adjustment is set at a minimum
Sediment on the transducer
Water too cold
Water is not clean
SOLUTIONS
Plug in the appliance
Turn on main switch
Add water to the tank
Close the lid properly
Fill the tank
Correctly reposition the water level
indicator
temperature for half an hour before
use.
Clean the tank and add clean water
Empty water from the groove and put
the tank back
Adjust intensity adjustment knob
Clean the transducer
Use water at ordinary temperature
Clean the tank and add fresh water.
Hello Kitty
EN
7