ROMPA 18549 Manual De Instrucciones página 4

If required, i.e. depending on your music system, it may be necessary to follow the steps outlined below:
1. Cut the speaker cables approximately 30cm from the plugs
®
2. Strip the ends of the wires attached to the plugs and connect to 'IN' of the ROMPA 2-way speaker control (splitter box).
®
3. Strip the ends of the wires attached to the speakers and connect to 'OUT' of the ROMPA 2-way speaker control (splitter box), Channel 1.
® ®
4. Connect the ROMPA product (i.e. Vibro Tub) to 'OUT' of the ROMPA 2-way speaker control (splitter box), Channel 2.
® ®
5. Use the switch on the ROMPA 2-way speaker control (splitter box) to direct the sound to either: Speakers, ROMPA product (i.e. Vibro
Tub) or both.