Care And Maintenance - Costco 1500138 Instrucciones De Montaje Y Cuidado

Troubleshooting:
If water does not flow out of unit,
little while underwater to dislodge any air bubbles trapped in the impeller cavity.
Connect and disconnect the power a few times. The pump should function.
Wait at least 20-30 seconds in order to allow the water to circulate properly.

Care and Maintenance:

Keep the water clean at all times.
o
Remove all forms of debris.
o
Never run the pump dry.
o
Verify water level frequently to compensate for evaporation during the summer. Fill within 2.54 – 5.08 cm (1-2 inches) below the
o
rim of the base (Fountain – Lower section).
Not for operation below 5° C (41° F). All water must be removed from the unit in freezing conditions.
o
This fountain is for outdoor decorative use only.
o
This fountain is designed to function with water only.
o
Never leave a running fountain unattended.
o
The water in the fountain is not safe to drink.
o
Keep away from small children and pets.
o
Change the water regularly to prevent the proliferation of mosquitoes.
o
During Winter, this fountain must be stored indoors. Please follow the following steps:
Disconnect power supply.
o
o Carefully empty fountain of all water.
o Store indoors on water-resistant surface.
WARNING!
RISK OF ELECTRICAL SHOCK!
This pump is supplied with a grounding conductor and grounding type plug. To reduce the risk of electric shock, be certain
that it is connected to a properly grounded, grounding type receptacle.
Always disconnect power supply before manipulating fountain.
Connect only to a grounded outdoor power outlet of 120V- 60Hz.
Do not attempt to repair a damaged pump/power cord. Ask for a replacement pump/cord from the manufacturer.
To avoid possible injuries do not tamper with pump/cord assembly.
Must be used only with the pump AND/OR transformer AND/OR adapter provided.
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
Made in China Fabriqué en Chine / Hecho en China
/
disconnect the power supply
and verify that there are no kinks in the hose. Shake the pump a