Auto Shut-Off; Preliminary Settings - Russell Hobbs Quiet Super Steam Pro Manual Del Usuario

BEFORE FIRST USE
• Remove any labels, stickers or packaging from the iron and soleplate.
• Before using the iron for the first time, or if it's not been used for a long time, iron a scrap piece of
cotton (an old towel is ideal) to remove any accumulated residues.
• Don't worry if the iron smokes a bit at first, it will soon stop as the manufacturing residues evaporate.

AUTO SHUT-OFF

If you don't press the steam trigger for 10 minutes your iron's auto shut-off feature will operate. The
thermostat light and the on/off button will flash to tell you that it is in auto shut-off mode. To cancel the
auto shut-off mode, press the steam trigger. Note that your iron will need time to heat up again to the
selected temperature. Wait until the temperature light has stopped flashing before resuming ironing.
FILLING/REFILLING
• Don't add anything to the water and don't use water with anything added to it. When the water is
converted to steam, chemicals, perfume, and other additives will coat the inside of the steam
chamber, shortening the life of the iron.
1. Press the water tank release button and pull the water reservoir away from the body of the steam
generator (fig. A).
Fill the reservoir to the max mark. Do not exceed the max mark.
2.
3. Refit the reservoir into the base unit pushing it in until it clicks.
• A warning light (d)will come on and the unit will beep twice when the reservoir needs refilling. If the
reservoir is empty, the steam function will stop working after one minute, however, you can still use
your iron without steam.

PRELIMINARY SETTINGS

1. Put the iron on top of the base unit.
2. Put the plug into the power socket (switch the socket on, if it's switchable).
3. Turn the unit on by pressing the on/off button.
USING
The temperature of your iron is safe to use on all ironable fabrics and garments.
DRY IRONING
1. Set the steam control to n ..
2. When the temperature light stops flashing your iron is ready to use.
STEAM IRONING
1. Set the steam control to the setting you want, n . = no steam, x = high steam.
2. Squeeze the steam trigger to produce steam, release it to stop.
• Your steam generator produces steam very efficiently so use the trigger in short, controlled bursts.
Too much steam can wet the fabric or cause condensation issues on your ironing board. Steam can
also be reduced by setting the steam control to a lower setting.
NOTE: When you first start your steam generator and pull the trigger for steam ironing, there will
be a delay as your steam generator pumps water from the reservoir to prime the system. This is
normal and may take 20-30 seconds. This will also happen after refilling the reservoir.
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE