After Use; Care And Maintenance - Russell Hobbs Quiet Super Steam Pro Manual Del Usuario

VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
• Check that there's adequate ventilation behind the fabric, otherwise moisture may build up, causing
mildew.
• Check that there's nothing behind the fabric that may be damaged by the steam.
• Check that pockets, turn-ups, and cuffs are empty.
1. Lift the iron off the fabric.
2. Squeeze the steam trigger to produce steam, release it to stop.

AFTER USE

1. Put the iron on top of the base unit.
2. Switch the appliance off and unplug it.
3. Empty the reservoir.
4. Let the iron cool down completely before cleaning it, moving it, or storing it away.
5. The steam pipe can be coiled together and placed into the hose clip.
6. Wrap the mains cable around the steam generator then slot the plug into the plug storage socket.

CARE AND MAINTENANCE

1. Unplug the base unit, and let the appliance cool down fully.
2. Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid.
3. Remove spots from the soleplate with a little vinegar.
4. Take care not to scratch the soleplate
ANTI-SCALE FILTER
To extend the life of the appliance and to avoid problems with lime scale, your steam generator is fitted
with an anti-scale filter. When the anti-scale filter needs cleaning, the anti-scale filter warning light (a) will
come on. If the warning light comes on when you are ironing you can continue without cleaning the filter.
The next time you use your steam generator the light will flash and the unit will beep three times. The filter
must be cleaned before using your steam genreator again.
Before attempting to remove and clean the filter you must unplug and allow the appliance to stand
for at least 1 hour to allow any built up steam and heat to dissipate.
To clean the filter:
1. Switch off and unplug your steam generator
2. Remove the iron from the top of the generator to expose the cover beneath.
3. Open the cover.
4. Unscrew the plug underneath the cover and lift the plug and filter assembly out of the base (Fig B).
5. Remove the filter from the plug by twisting it (fig C).
6. Rinse the filter under a tap to remove any deposits. Use a soft brush if necessary.
7. Replace the filter onto the plug and twist it until it locks.
8. Refit the plug and filter assembly into the base and tighten it firmly. Close the cover.
9. Plug in your steam generator.
10. Reset the warning light by pressing and holding the anti-scale warning light/reset button (a) for 3
seconds until the light goes out.
11. Once the appliance is ready, pull the steam trigger until the steam is being produced. This will prime
the system.
Important: Using the appliance without cleaning the filter can cause a reduction in the generated steam
output and damage the appliance. The guarantee will not cover damage caused to the appliance by not
cleaning the anti- scale filter when required.
Do not clean the anti-scale filter in a dishwasher. Wash by hand only using a soft bristled brush if necessary.
6