Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Periodic visual inspection of this bath seat is recommended
to ensure that all parts and hardware are secure, that
components are in good working order and not worn,
torn, frayed, or loose, and that there are no obstructions
or impediments to normal, safe operation. If any part or
mechanism appears to be unsafe or damaged, do not use
the product. If you experience problems, please contact
Medline at 1-800-MEDLINE.
ASSEMBLY:
1. Open box and make sure it
contains all parts described
in this manual.
2. Place seat upside down on
a flat surface so the four leg
receptacles are facing upward.
3. Insert first leg into the leg
receptacle by depressing
pushbutton. When the leg is
in place, the pushbutton will
extend out and lock the leg in
place. (Figure 1)
4. Repeat Step 3 for the remaining
three legs.
5. Attach backrest to seat by
inserting both back support tubes
into the back support receptacle
on the seat. The pushbuttons
will snap out and lock the back
support in place. (Figure 2)
Adjusting Leg Height
1. Before using the seat, make sure all
legs are set to the same preferred
height.
2. To do so, depress pushbutton and
slide each leg to desired height by
aligning with proper holes and letting
the pushbutton snap into the correct
hole to lock leg in place. (Figure 3)
Figure 1
Figure 2
Figure 3
G2-102KX4 G2-102KX1 (PIC-00303)
REVISED: 03/26/20
Publicidad
