Publicidad
Idiomas disponibles
Idiomas disponibles
Step 5: Add Safety Bolts
Thread a Safety bolt (S) into the threaded hole on each side of the Transfer Bracket and tighten them with a phillips screw-
driver until they are tight. See the detailed View of Diagram 5 for assistance.
Detailed View
Diagram 5
Transfer
Bracket
S
NOTE: Lower Hole on transfer bracket may be used to add a padlock for added security.
Step 6: Leveling and Adjusting Tension on the Monitor
CAUTION: Do not remove the Tension Nuts labeled in Diagram 6a.
Once the television is mounted onto the Wall Plate (A), and the Safety Bolts (S) are tight, it can be adjusted to level. Slightly
loosen the two Allen Bolts on the back of the Arm Assembly (B). Once those two bolts are loosened, the television can be
adjusted ±6º until level. When the television is level retighten the two Allen Bolts. The tilt can be adjusted by simply tilting
the television. If you need to adjust the tension of the tilt, you can do so with the Tension Knobs. The Tension Nuts labeled
in Diagram 6a can be slightly loosened or tightened to adjust the tension of the Arm Assembly. If you need to adjust the
Tension Nut closest to the TV, you must remove the Safety Bracket, adjust the tension and re-install the Safety Bracket as
shown in the Safety Bracket installation view of Diagram 6b.
Diagram 6a
Diagram 6b
Tension
Safety
Nut
Safety
Bracket
B
Bracket
Allen
Bolts
Tension
Knobs
Tension
Nut
Publicidad
