Publicidad
Enlaces rápidos
Publicidad
Manuales relacionados para Subzero SZ-RS100
Resumen de contenidos para Subzero SZ-RS100
- Página 1 SUBZERO RECORDING STRIP SZ-RS100 USER MANUAL...
- Página 2 WARNING! ATTENTION! Do not open cover. No user-serviceable parts inside. Refer servicing to qualified Ne pas ouvrir le couvercle. Aucune pièce interne réparable par l’utilisateur. Confier la service personnel réparation a du personnel de réparation qualifié Do not place the product in a location near a heat source such as a radiator, or in an Ne pas laisser l’appareil à...
- Página 3 ATENÇÃO! Não abra a tampa. Não tente a reparação do instrumento por si. Dirija-se a pessoal qualificado Não aproxime a uma fonte de calor excessivo ou exponha o produto à luz solar, poeira, vibração ou choque Não mantenha o produto num local húmido ou perto líquidos como vasos, etc. Não aproxime o produto a fontes de fogo vivo, como velas Mantenha o produto num espaço suficientemente arejado de forma a evitar sobre- aquecimento.
-
Página 4: Features Overview
WELCOME Thank you for purchasing the SubZero RS100 • Switchable dynamic enhancer to compensate for Recording Strip. To get the most out of your new high frequency loss by boosting content above product, please read this manual carefully. 2.5kHz FEATURES OVERVIEW •... - Página 5 OVERVIEW PRE AMP EXPANDER / GATE 1. SENSITIVITY SWITCH 8. EXPANDER/GATE TRIGGER Determines the sensitivity of the input. This control determines the threshold below Pressed = LINE, UnPressed = MIC. which expansion sets in, so that signals below threshold are reduced in gain. The setting 2.
- Página 6 OVERVIEW COMPRESSOR / LIMITER 12. COMPRESSOR THRESHOLD Note: With the SC MONITOR switch activated, This control adjusts the compressor threshold only the side-chain signal will be present at from -40dB to +20dB. the output, which is shown by the flashing LED switch.
- Página 7 DE-ESSER 19. COMPRESSOR ATTACK CONTROL 25. DE-ESSER LEVEL CONTROL This determines when the compression sets in The controllable de-esser helps to eliminate once the signal has exceeded threshold. hiss noise contained in the audio signal. This The setting range is from 0.3 to 300ms. control determines the amount of frequency suppression.
- Página 8 OVERVIEW PARAMETRIC EQUALIZER OUTPUT 29. EQ LOW LEVEL 38. OUTPUT LEVEL LED MONITOR/METER Controls the low frequency level at 80Hz by 12bit LED output monitor displaying from -/+15dB. -30dB to +18dB. 30. EQ LOW-MID FREQUENCY 39. MAIN OUTPUT LEVEL Controls the main outout level by -/+20dB. Controls the frequency of the low-mid range between 60Hz and 2.4KHz.
- Página 9 OVERVIEW 41. AC INLET AND FUSE HOLDER Use the supplied AC cord to connect the unit to AC mains. Make sure voltage and frequency stated and set on the unit comply with your local AC supply. The fuse can be accessed by the small drawer at the AC inlet.
- Página 10 SPECIFICATIONS Signal/Noise ....>90dBu (22Hz-22KHz) THD..... . <0.05% (Line) Frequency response .
- Página 12 If you have any more questions about this product, please do not hesitate to contact the Gear4music Customer Service Team on: +44 (0) 330 365 4444 or info@gear4music.com...