Temperature Setting - IARP WW 130 E Instrucciones De Empleo Y Manutención

TANK CLEANING
For tank cleaning proceed as follows:
1) Empty the appliance
2) Take the plug out
3) Wash and dry the tank using neutral soap and soft cloth. Plug in again and load the product.
Warning! Do not use jet of water and steam to clean the cabinet: electrical wiring could be damaged.
Warning! Never use mechanical devices or any other means to accelerate the cleaning, other than
those recommended by the manufacturer.
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the
temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can proceed as follows:
- press the (Set) key until you hear a "beep" sound (approximately 2 seconds).
- press the (▲) key or the (▼) key in order to increment or decrement the temperature set point
- press the (Set ) key in order to store the new temperature set point.
MALFUNCTIONS AND REMEDIES
Most of the inconveniences are generally due to defective electrical connections. These problems can
usually be solved on the place.
The unit does not start:
-check that there is voltage at the wall socket;
-check that the unit is properly plugged.
The internal temperature is not cold enough:
-check that the unit is not placed too close to any heating source;
-check that around the cabinet air can properly circulate;
-check the perfect closing of the doors.
The unit is noisy:
-check that all the bolts and nuts are properly fasten;
-check that the unit is placed on an even surface.

TEMPERATURE SETTING

INFORMATIONS ABOUT SERVICE
-9-