Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
8
•
Fit an extension (not included) if required to the square drive (A).
•
Set ratchet function direction on the direction switch (B).
•
Install properly sized socket/attachment to the square drive (A).
•
Set the direction switch (B) to tighten position.
•
Operate the torque wrench the same as a standard socket wrench to
tighten the bolt/nut.
•
Place the socket on bolt/nut and tighten slowly and steadily until
the "click" sound is heard. Stop pulling the wrench and release the
pressure on the handle (D). The bolt/nut is now tightened to the
required torque setting.
•
Do not continue to pull after the torque setting is reached. Doing so
will over-tighten the bolt/nut and could damage the wrench.
Maintenance
•
The product is lubricated for life and should not be oiled. The only
exception is the ratchet mechanism which may be lubricated as
needed for smooth operation.
NOTICE
This product is a precision measuring instrument.
Calibration must be done regularly to ensure accuracy. It is recommend
to re-calibrate the product no later than 10,000 cycles or 12 months after
the date it is put in service, whichever comes first.
Storage
•
This product is a precision instrument and should be stored with care
using provided storage box. Avoid any vibrations and shocks.
•
Set the torque to the lowest level before storage.
Specifications
Model number:
Maximum torque value:
Accuracy:
Net weight:
Dimensions (W x H x D):
B07SZVW98Z
35 – 200 in-lb
(3.95 – 22.5 Nm)
+/–4 %
approx. 1.2 lbs (560 g)
approx. 1.1 x 1 x 10.4"
(28 x 26 x 265 mm)
Publicidad
Tabla de contenido
