Display Functions - Zepter AqueenaPro WT-100 Manual De Instrucciones

Warning!
Pay attention to the direction of the membrane; the membrane ending with an O-ring must be placed
in the bottom part of the housing.
• Do not force the RO membrane into the membrane casing; it may cause permanent damage
to the membrane shell or membrane components.
• If the RO membrane is installed correctly in the membrane housing, there is no need to force it.

Display functions

If a display icon lights up:
Working:
Water
Source:
Standby:
Flush:
Note!
If any leaks occur, all icons ("Working", " Water source", "Standby" and "Flush" icons) will
fl ash at same time along with an audible alarm.
1 2
Filter Status Display: It shows the actual fi lter status.
3 5
Green light – the fi lter works at its optimum level.
Orange light - the fi lter will soon need replacing. Please contact Zepter Service for maintenance
support.
A red light along with an audible alarm (4 buzzes) means that the fi lter must be changed immediately.
Further use of the fi lter is not recommended.
1 5 – micron PP fi lter WT-100-72
2
Pellet carbon fi lter WT-100-73
3 1 – micron PP fi lter WT-100-74
5 Coconut fi lter WT-100-75
Water purifi cation is in the progress, the device is in working mode.
Flashing light - missing inlet water source or low inlet water pressure.
The "Water source" icon will light up with an audible alarm (7 buzzes).
The water purifi er is in standby mode.
The fl ushing function is activated.
EN
15