Restoring Leakage Sensor - Zepter AqueenaPro WT-100 Manual De Instrucciones

EN

Restoring Leakage sensor:

1. Turn off the power supply
2. Close the inlet water valve
3. Remove the top cover
4. Repair the leakage
5. Drain the water out of the housing by removing the rubber cap at the bottom of the housing.
6. Dry the sensor
Warning!
When installing a new fi lter, pay special attention to water fl ow direction – the arrow on the fi lter label
shows the correct water fl ow direction.
The fi lter cannot be installed upside down.
17