Using The Controls - Kitchen Aid KUWR204EPA Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using the Controls

The control panel for the wine cellar is located on the middle
separator (mullion) of the wine cellar. The control of the wine
cellar has no mechanical parts or buttons. When disconnected,
the control panel displays nothing and may be difficult to locate.
Turning Control On/Off
The first time that the wine cellar is plugged in, the control will
be in Cool Off mode. Cool On and Cool Off will be the only
options that display.
Press COOL ON for 3 seconds to turn on the wine cellar. All
menus and recommended temperature settings will be
displayed.
The left temperature and preset touch pads control the
temperature of the upper compartment.
The right temperature and preset touch pads control the
temperature of the lower compartment.
Viewing Celsius Temperatures
Press the F/C touch pad to toggle between displaying the
temperature in degrees Fahrenheit and degrees Celsius. The
corresponding indicator will illuminate.
A. F/C touch pad
Adjusting the Control
When the wine cellar is turned On for the first time, the
temperature defaults to the recommended setting. There are two
adjustable temperature controls, with one for each compartment.
NOTE: The set point for the wine cellar is 50°F (10°C) for both the
upper and lower compartments. The set point range for the
upper compartment is 42°F to 54°F (5°C to 12°C) and 42°F to
64°F (5°C to 17°C) for the lower compartment
The control is set correctly when the wine is as cold as you like it.
NOTE: Wait at least 24 hours between adjustments for the
product to acclimate. Recheck the temperatures before making
further adjustments.
Using Presets
For your convenience, your wine cellar also has controls that are
preset to recommended storage temperature for specific wines.
Pressing any preset option will set the temperature to the
recommended temperature for the specified wine:
The wine cellar has a sensor that will turn on the interior display
light automatically when someone walks by. When motion is no
longer detected, the interior display light will go off after 2
minutes.
A
NOTE:
To adjust set point temperatures, press "+" (plus) or "-"
(minus) until the desired temperature setting is reached.
Assorted: 54°F (12°C)
Champagne: 46° (7°C)
Red Wine: 64°F (17°C)
Sweet Wine: 42°F (5°C)
White Wine: 50°F (10°C)
Auto Light
Press the Auto Light option to activate this feature.
When the Auto Light is not activated, the interior display light
will only turn on when the door is opened.
Leaving the light on for an extended period of time will slightly
increase the temperature of the wine cellar.
The light is an LED, which does not need to be replaced.
However, if the LED does not illuminate when the door is
opened, call Service to check the problem and replace, if
necessary. See "Assistance or Service" for contact
information.
9 9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Kuwl204epa

Tabla de contenido