UPRIGHT FREEZER SHOWCASE
Original Instructions
t
HSC300N
Positioning
Possible placement positions:
1.
In a way that the back side alone is opposite to the wall; be careful that there is a gap of 150 mm (15 cm) between the wall and your device. (Picture 6)
2.
In a way that is place to a corner; when you place it to a corner, leave a gap of 150 mm (15 cm) behind. You can lean the side, corresponding to the corner,
to the wall.
The most important point to be considered in all cases of product placement is not to obstruct ventilation of the compressor assembly.
Without exposing your product to any slope, place and operate it in a manner that it is on its feet and wheels.
The freer the compressor assembly ventilation is, the better the device will run.
PICTURE 6
Installation
1.
Before positioning, remove and disassemble all packaging materials and bottom wooden pallet of the product. (It may be necessary to lift your device for
removing the bottom pallet).
2.
Place the product where you desire. Consider the placement rules written in the manual while positioning the product.
3.
Balance your product in width and in depth by means of a water gauge. Please perform optional balancing operation by means of the adjustable feet at the
bottom front of your product. (Picture 7)
Batteries for LCD display
Steps to install or replace batteries:
•
Dismounting top cover (1)+(2) and thermostat knob (3). (Picture 8)
•
Loosen two screws behind cover (4)+(5) with screw driver (6). (Picture 9)
•
After removing 2 screws, the front panel can be taken off. See back side of the panel.
•
Remove the battery cover (7). (Picture 10)
•
Cover is open (8). (Picture 11) Take out the used batteries (Type: LR44 X 2) and replace
with new batteries.
•
Make sure the batteries are in correct polarity positions.
•
Close the battery cover.
•
Putting back the display unit to its position.
•
Keeping children safe from button batteries.
4
6
PICTURE 9
Electric Connection Rules
The product will start when you insert the plug into the outlet.
WARNING!
•
It is forbidden to insert the plug into multiple socket and to use extension cord. (Picture 12)
•
There is no separate on-off switch on your product.
•
Do not contact the cables of your product, which are connected to the mains, to hot surfaces.
(IM)961-000669_HSC300N_GB&DE_IM_V5_161121.indd 8
PICTURE 7
5
7
PICTURE 10
- 8 -
1
3
2
PICTURE 8
8
PICTURE 11
11/21/16 2:21 PM