Using The Cassette Player - THOMSON RK300CDU Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

USING THE CASSETTE PLAYER

Playing cassettes
• Set the FuNCTIoN selector to TAPE.
• To open the cassette compartment (20), press
• Insert an audio cassette in the compartment, tape side up, with the side to be
played in the forward direction (rewound side on the right). Close the cassette
compartment (20).
• To play the cassette, press
(15).
• To stop playback, press 3/
.
• If necessary wind the tape forward or back by pressing 5 or 6. Press 3/
the tape winding.
Note: To avoid damaging the appliance or the tape always press 3/
the tape winding direction.
• To stop playback for a short time, press 2. Press this button again to resume
playing the tape.
• Set the volume.
• During playback, press 3/
once to stop playback, then press it again to open the
cassette compartment door.
Recording cassettes
• Insert a blank audio cassette in the cassette compartment, with the side to be
recorded in the forward direction (full spool on the right). Make sure that the
cassette is not write-protected (the protection strip on the cassette must not be
broken).
• Use the FuNCTIoN selector to select the recording source:
To record from the radio, set the function selector to RADIo then set the required
radio station.
To record from a CD, put a CD in the CD compartment. Set the FuNCTIoN selector
to CD and select the required track.
• Press 12 to start playback.
The recording level is controlled automatically. Changing the volume has no effect
on the recording.
• Press the recording button
. Recording begins.
Note: If the cassette is not blank any previous recordings will be automatically
overwritten.
• To completely stop recording, press 3/
PORTABLE CD CASSETTE
.
to stop
before changing
.
RADIO RK300CDU
USING A USB KEY (not supplied)
The appliance is equipped with a USB port (7), so you can play music files from a USB
key.
• The appliance must not be in the process of playing a disk.
• Set the FuNCTIoN selector to CD/uSB.
• Insert a USB key into the appliance's USB port (7).
• Press and hold the CD/uSB selector's 12 to play the contents of the USB key.
The playback functions are identical to the CD playback functions.
Note:
• Do not remove the USB key while the files are being played as this could damage
them.
• You are recommended to save the key's contents in order to avoid losing data.
• ATTENTIoN: Maximum capacity 4 GB. The player does not handle all USB devices
(e.g. external hard disk, etc).
EARPHONE SOCKET (not supplied)
Earphones (not supplied), with a 3.5mm Ø earphone jack and not exceeding 100dB, can
be connected to the appliance.
• Plug the earphones into the jack PHoNES.
Note: When the earphones are connected the speakers are automatically inactive.
Use the appliance at a comfortable sound level to preserve the user's health.
• Connect an audio device to the AuX IN jack, using an audio cable (29) (not
supplied).
• Switch the appliance on.
• Set the FuNCTIoN selector to AuX IN.
• Use the device's controls directly.
AUXILIARY FUNCTION
11
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido