Plidco Split+Sleeve Instrucciones De Instalación página 5

7. Ensure the nylon slings are taut or, if not taut, with a minimum amount of slack when the sleeve is
in its open position. This will prevent the nylon slings from getting trapped between the sleeve
and the pipe when the sleeve is closed
8. Lower the hinged assembly onto the pipe when the Split+Sleeves is configured as shown in
Figure 6. The slings will contact the pipe first and cause the hinged assembly to close around the
pipe as shown in Figure 6 and Figure 7.
Figure 5
Figure 6
Page 4 of 5
IP-017
Revision 1