Tektronix TDS3BATB Manual De Instrucciones página 2

Charging the Battery Pack
The battery pack charges automatically when the
oscilloscope is connected to line power. For a
more efficient charge, use the optional external
charger (TDS3CHG).
When the battery pack is in the oscilloscope, the
gauge icon ( ) on the display indicates the
amount of charge.
S
To avoid automatic shutdown of the battery
pack, run the oscilloscope on the battery pack
only when the gauge indicates sufficient
charge.
S
To ensure the accuracy of the gauge, occasion-
ally allow the oscilloscope to run on the bat-
tery pack until automatic shutdown occurs.
NOTE.
The TDS3CHG external charger may
increase the available charge and reset the
gauge to a higher level. Subsequent charges
using the oscilloscope may indicate less than
a full charge.
Configuration Typical charging time
Battery pack charging in 30 hours
oscilloscope with
oscilloscope turned on or off
Battery pack charging with 5 hours
TDS3CHG external charger
CAUTION.
To avoid damage to the battery
pack, use only the oscilloscope or the
TDS3CHG battery charger to charge the
battery pack. Do not connect any other
voltage source to the battery pack.
NOTE.
Charge the battery pack completely
before using it for the first time or after
prolonged storage.
www.tektronix.com
To discharge the battery pack completely, continue
to run the oscilloscope on the battery pack until
automatic shutdown occurs.
NOTE.
and to prevent shutdown, do not operate or
charge the battery pack at high
temperatures. For best results, allow the
battery pack to cool to room temperature
before using or charging the battery pack.
The battery pack stops charging under the
following conditions:
S
The battery pack is fully charged.
S
The battery pack temperature exceeds the
operating temperature specification in the
table below.
The battery pack shuts down and disconnects
itself from the TDS3000/TDS3000B series
oscilloscope under the following conditions:
S
The battery pack is fully discharged.
S
There is a fault current that exceeds 5 A for
longer than 32 ms.
Replaceable Parts
Grounding wire
Specifications
Input from
TDS3CHG
Output
Operating
Temperature
Storage
Temperature
Optional
TDS3CHG
To prolong the life of the battery pack
174-3997-00
30 W, 18 VDC
14.4 VDC, 5400 mAh
0 °C to 50 °C , discharging
0 °C to 45 °C , charging
- - 20 °C to +50 °C, short term
- - 20 °C to +35 °C, long term
Certifications and compliances
Australia/New Zealand Declaration of Conformity - - EMC
Complies with EMC provision of Radiocommunications Act
per the following standard(s):
AS/NZS 2064.1/2 Industrial, Scientific, and Medical
Equipment: 1992
EC Declaration of Meets the intent of Directive
Conformity - - 89/336/EEC for Electromagnetic
EMC Compatibility when it is used with the
product(s) stated in the specifications
table. Refer to the EMC specification
published for the stated product. May
not meet the intent of the directive if
used with other products.
FCC Compliance Meets the intent of the FCC Code of
- - EMC Federal Regulations 47, Part 15,
Subpart B, Class A Limits.
WARRANTY SUMMARY
Tektronix warrants that the products that it
manufactures and sells will be free from defects in
materials and workmanship for a period of three
(3) months from the date of shipment from an
authorized Tektronix distributor. If a product or
CRT proves defective within the respective period,
Tektronix will provide repair or replacement as
described in the complete warranty statement.
To arrange for service or obtain a copy of the
complete warranty statement, please contact your
nearest Tektronix sales and service office.
EXCEPT AS PROVIDED IN THIS SUMMARY
OR THE APPLICABLE WARRANTY
STATEMENT, TEKTRONIX MAKES NO
WARRANTY OF ANY KIND, EXPRESS OR
IMPLIED, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR
A PARTICULAR PURPOSE. IN NO EVENT
SHALL TEKTRONIX BE LIABLE FOR
INDIRECT, SPECIAL OR CONSEQUENTIAL
DAMAGES.
Contacting Tektronix
1- - 800- - 833- - 9200*
Phone
Tektronix, Inc.
Address
Department or name (if known)
14200 SW Karl Braun Drive
P.O. Box 500
Beaverton, OR 97077
USA
www.tektronix.com
Web site
1-800-833-9200, select option 1*
Sales
support
1-800-833-9200, select option 2*
Service
support
Email: techsupport@tektronix.com
Technical
1-800-833-9200, select option 3*
support
6:00 a.m. - - 5:00 p.m. Pacific time
*
This phone number is toll free in North America. After
office hours, please leave a voice mail message.
Outside North America, contact a Tektronix sales office
or distributor; see the Tektronix web site for a list of
offices.
Copyright © Tektronix, Inc.
Beaverton, OR 97077