Preparation For Use; Unpacking And Set Up; Power Source - SOUNDMASTER NR976 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32

UNPACKING AND SET UP

Carefully remove the unit from the display carton and remove all packing materials from the
unit.
Unwind the AC power cord and extend it to its full length.
Unwind the UKW Antenna wire and extend it to its full length.
Place the unit on a stable, level surface, convenient
to an AC outlet, out ,of direct sunlight and away from
sources of excess heat, dust, moisture, humidity or
strong magnetic fields.
Open the CD door. Lift the CD diskette cover, remove
the transit card which was used to secure the laser
during shipment and dispose of this card
Connect the plug to your AC outlet.

POWER SOURCE

This system is designed to operate on normal 230V 50Hz
AC only. Attempting to operate this system from any
other power source may cause damage to the system
and such damage is not covered by your warranty.
IMPORTANT: Raising And Lowering The CD Door
To open the lid, raise it as far as it will go until the lid support bracket 'locks' into the open
position
To close the lid, lift it upward slightly until the lid support bracket 'unlocks' and then gently
lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID
CLOSED.ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
Door support bracket, pull
forward to release and
lower door.

PREPARATION FOR USE

1
NR976 / English Instruction Manual
To Raise The Door,
Lift Here.

Publicidad

Tabla de contenido
loading

Tabla de contenido