Installation Update; Weak Channel Installation; Installation Mode; Uninstall Channels - Philips 26PFL5302D/37 Manual Del Usuario

Notes:
• When you have locked TV channels while initiating autoprogram, a message appears asking to enter your PIN code in order to complete autoprogramming.
• When interrupted, the updated channel information is retained as well as the not yet updated old channel information.
• Background autoprogramming occurs only when the TV is turned on.
• Channel information of an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies and update information.
• Weak channel installation : This allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that
channel.
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
Note: Digital Channel selection delay
Due to the tuning complexity of subchannel digital
programming, the time to select and view a digital
channel may take slightly longer than what the viewer
is normally accustomed to (as compared to analog
channel programs).
Digital channel broadcasts contain program and
system data information that must be processed
before the channel selection can be displayed.
Channel tuning
Available channels:
- Cable (analog NTSC or digital QAM): max. from 1 to 125
- Antenna (analog NTSC or digital ATSC): max. from 2 to 69
If a tuned channel is not yet in the master channel map, the TV will attempt
to tune the channel and it will be added to the map.
If the channel is not acquired, a message will appear that the channel is not
available.
When you tune an audio-only digital subchannel, a display appears with the
message Audio only .
Note: Subchannel selections
- The new standards employed with digital broadcasting make it possible to receive
multiple program channels under a single major channel number which can be
selected by pressing the digit remote control direct-acces channel number entry.
- The number of channels shown at installation includes paid channels but you
may not be able to see all of them unless you sign up with cable TV operators.
:
Important
After the installation of the TV channels has been done, always make a selection
in the Installation menu between Antenna or Cable whether you want to watch
Antenna TV channels or Cable TV channels.
If you make use of a signal splitter do not forget to put the switch in the
corresponding position.

Installation update

(only with Digital TV broadcasting)
This allows you to automatically tune to and update all available digital channels.
Notes: - this will not reinstall uninstalled channels;
- digital channels that are not encountered any longer will be removed;
- new channels found will not be added to any favorite list;
- already installed channels will not be renumbered.

Weak channel installation

This enables you to do a weak ATSC digital channel installation. This is only
available for TV channels installed via an antenna connection.
&
If a certain channel you expect to see is not tuned or is weak, you can install
it manually. Call your local broadcasting station to know what channel its
being transmitted on.
é
Select that channel in the displayed list of TV channels (in the antenna mode).
" The signal strength is displayed and updated continuously as you rotate the
antenna.

Installation mode

This allows you to select the already stored terrestrial or cable TV channels.
Choose for Antenna or Cable whether these signals are present.

Uninstall channels

This allows you to uninstall a stored channel so that it is no longer possible to
tune to. This also allows you to reinstall an earlier uninstalled channel.
& Select the channel you want to uninstall.
é
Press the green color button to uninstall the selected channel.
The uninstalled channel is indicated in the list by an icon in front of the
uninstalled channel.
" Press the green color button again to reinstall the uninstalled channel.
Note : Uninstalled channels are not reinstalled during an installation update.
18