Connection Diagram - Quick CHALLENGER Serie Manual De Uso Y Mantenimiento

CONNECTION DIAGRAM

EN
CONNECTION DIAGRAM
WIRING DIAGRAM
Power
bus
wiring
INTERNAL SIDE OF JUNCTION BOX COVER WITH
'WIRING DIAGRAM' ADHESIVE LABEL.
CLG60 RGBW system - control from DMX control device
SCREW
JUNCTION BOX
WITH INTERNAL
DRIVER
JUNCTION BOX
WITH INTERNAL
DRIVER
1 2 3 4 5 6 7 8 9 G
Power
Driving
bus
cable
wiring
wiring
DMX512
CONTROL DEVICE
DMX COMMAND
SIGNAL
TWO CABLES BUS
(POWER BUS)
WARNING: position the power supply box in an area clear of flam-
mable gases or vapors.
WARNING: DO NOT CONNECT DIRECTLY TO THE POWER
LINE (220VAC).
WARNING: DO NOT CONNECT DIRECTLY TO THE ON-BOARD
ELECTRICAL SYSTEM*.
Undo the 4 screws of the cover to reach the driver. Connect the cables
as shown in the internal adhesive label threading them through the spe-
cific cable outlets.
Make all the connections to the junction box containing the driver fol-
lowing the instructions shown in the sticker affixed to the internal cover
of the box.
For the POWER BUS connection use a cable having a size suitable for
charge. We recommend a 2x2.5 mm
The POWER BUS connection has no polarity.
The cable is not included in the package.
QCC-PLT 300*
This is an essential electronic device to man-
age the CLG RGBW by using a bus with two
wires for supplying power and the control
signal to the CLG QCC RGBW drivers.
Not included in the package.
Consult the QCC-PLT300 manual for
instructions to properly use the device.
QCC-PLT 300
20-30VDC
CABLE OUTLET
TWO CABLES BUS
(POWER BUS)
16
QCC CLG60 RGBW - REV001B
cable.
2
EACH QCC-PLT 300
CAN DRIVE UP TO
5 CLG60 RGBW
QCC CLG60
RGBW
QCC CLG60
RGBW
QUICK SPA