Safety Warnings - Marmitek STEREOCONTROL Guia Del Usuario

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in dry spaces. Do not expose
the components to rain or moisture. Do not use the product close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright light sources.
• Do not open the product: the device contains live parts. The product should only be repaired or
serviced by a qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product yourself, all
guarantees expire. Marmitek does not accept responsibility in the case of improper usage of the
product or when the product is used for purposes other than specified. Marmitek does not accept
responsibility for additional damage other than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• Batteries: keep batteries out of the reach of children. Dispose of batteries as chemical waste. Never use
old and new batteries or different types of batteries together. Remove the batteries when you are not
using the system for a longer period of time. Check the polarity (+/-) of the batteries when inserting
them in the product. Wrong positioning can cause an explosion.
INTRODUCTION
Congratulations on the purchase of the StereoControl! With the StereoControl you can extend infrared
signals from your remote control. In this way you can continue to control your A/V-devices which are
behind closed cabinet doors or out of sight with your own remote control. The StereoControl consists of
an infrared receiver with two connected infrared (IR) LEDs. see Fig. 1.
• In the receiver you find a battery compartment for a 9 Volt battery.
• The two IR LEDs are equipped with a self-sticking foil. In this way, you can connect both IR LEDs to the
Infrared display panel of your A/V-devices.
Fig.1 StereoControl IR Receiver
HOW DOES THE STEREOCONTROL WORK?
• The receiver is placed directly in sight of your remote control.
• The receiver converts the signal from your remote control to an electric signal and passes it on to the
two IR LEDs.
• You can stick these IR LEDs on the IR sensor of your A/V-devices. The IR LEDs light up when you
give the command with your remote control. In this way, all signals from your remote control are
transmitted to your A/V-devices.
• StereoControl works with almost all bands and models of remote controls. (with the
exception of B&O).
STEREOCONTROL TM
Side view Front view
IR LEDs
3