Safety Warnings; How Does Marmitek X-10 Work - Marmitek AW12 Manual De Instrucciones

INSTALLATION INSTRUCTIONS FOR
MARMITEK X-10 IN-WALL APPLIANCE
MODULE AW12

SAFETY WARNINGS

• The wiring of your electrical installation is live (230 V) and extremely dangerous. Never
connect the module when plugged into the mains. Always turn off the main switch
before starting the installation.
• This product is for professional use and should be installed by a certified installer.
• To prevent short circuits, this product should only be used inside and only in dry spaces.
Do not expose the components to rain or moisture. Do not use the product close to a
bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright
light sources.
• Do not open the product: the device contains live parts. The product should only be
repaired or serviced by a qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case of
improper usage of the product or when the product is used for purposes other than
specified. Marmitek does not accept responsibility for additional damage other than
covered by the legal product responsibility.
• Automatic switching devices provide comfort, but can also be dangerous. They can
surprise people or can ignite clothing hanging over an electric heat source. Please be
careful and take appropriate measures to avoid accidents.

How does Marmitek X-10 work?

Marmitek X-10 components use the existing mains wiring to communicate (using Marmitek
X-10 signals). You can build a complete system using the three different kind of components
of the Marmitek X-10 System:
1. Modules:
2. Controllers:
3. Transmitters:
AW12 TM
These components will receive Marmitek X-10 signals and will switch
or dim the attached lamp or appliance.
These components will transmit Marmitek X-10 signals and thus will
control the Modules.
Wireless components like remotes. The signals of these components
will be received by a controller with transceiver functionality (IRRF 7243,
TM13 or console of a Marmitek Security System). The Transceiver will
translate the signals into Marmitek X-10 signals on the power line.
3