Connect Hose And Water Supply To Pump; Important; Add Engine Oil And Fuel - Snapper 020230 Manual Del Operario

3. Insert one "L" hook through hole just above billboard
on left side of handle (viewing from front of unit). Hold
hook in place and attach a plastic knob from inside of
unit (Figure 3).Tighten by hand.
Figure 3 — Attach "L" Hooks to Handle
Spray Gun Hook
4. Insert other "L" hook through hole just below
billboard on right side of handle (viewing from front of
unit). Hold hook in place and attach a plastic knob
from inside of unit (Figure 3).Tighten by hand.

Add Engine Oil and Fuel

• Place pressure washer on a level surface.
CAUTION
Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.
• Refer to engine operator's manual for oil and fuel fill
information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator's manual and follow oil and fuel
recommendations and instructions.
NOTE: Check oil often during engine break–in. Refer to
engine operator's manual for recommendations.
2650 PSI Pressure Washer
Connect Hose and Water Supply to
IMPORTANT: To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
1.
Figure 4 — Connect High Pressure Hose to Spray Gun
Hose Hook
2.
Figure 5 — Connect High Pressure Hose to Water Outlet
8
Pump
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 4).Tighten by hand.
Connect high
pressure hose here
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 5).Tighten by hand.