Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Allow detergent to soak in between 3–5 minutes
before washing and rinsing. Reapply as needed to
prevent surface from drying. Do Not allow detergent
to dry on (prevents streaking).
IMPORTANT: You must flush the chemical injection
system after each use by placing the filter into a bucket of
clean water, then run the pressure washer in low pressure
for 1-2 minutes.
Pressure Washer Rinsing
For Rinsing:
1.
Apply safety latch to spray gun.
2.
Remove black chemical nozzle from nozzle extension.
3.
Select and install desired high pressure nozzle following
instructions "How to Use Spray Tips".
4.
Keep spray gun a safe distance from the area you plan
to spray.
WARNING
High pressure spray could cause you to fall if
you are too close to the cleaning surface.
• Keep spray nozzle between 8 to 24 inches away from cleaning
surface.
• Operate this unit on a stable surface.
• Be extremely careful if you must use the pressure washer from
a ladder, scaffolding or any other relatively unstable location.
• Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when gun kicks back.
2650 PSI Pressure Washer
5.
Apply a high pressure spray to a small area and then
check the surface for damage. If no damage is found,
you can assume it is okay to continue rinsing.
6.
Start at top of area to be rinsed, working down with
same overlapping strokes as you used for cleaning.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it
with clean water before stopping the engine.
1.
Place chemical injection siphon/filter in a bucket full of
clean water.
2.
Engage trigger lock on spray gun.
3.
Attach black low pressure spray tip.
4.
Flush for 1-2 minutes.
5.
Shut off engine.
6.
ALWAYS point gun in a safe direction and squeeze
spray gun trigger to release retained high water
pressure.
IMPORTANT: Spray gun traps high water pressure, even
when engine is stopped and water is disconnected.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
3-5 minutes without pressing the trigger on the spray gun,
circulating water in the pump can reach temperatures
above 125°F.The system engages to cool the pump by
discharging the warm water onto the ground.
13
Publicidad
Tabla de contenido
