Cutters
Depth _auge
Drive Links
• Place
the chain
over
and behind
the
clutch, fitting the drive links in the clutch
drum sprocket.
Place chain onto the sprocket
• Fit bottom of drive links between the teeth
in the sprocket in the nose of the guide bar.
• Fit chain drive links into bar groove.
• Pull guide bar forward until chain is snug in
the groove of the bar. Ensure all drive links
are in the bar groove.
• Hold guide bar against the saw frame mak-
ing sure the adjusting
pin is aligned
with
the hole in the bar. Remember
this pin
moves the bar forward and backward
as
screw is turned, install the chain brake.
• Replace the chain brake nuts and tighten
finger tight. Once the chain is tensioned
you will need to tighten chain brake nuts.
CHAIN
TENSION
(Including
units with
chain already installed)
NOTE:
When
adjusting
chain
tension,
make sure the chain brake nuts are finger
tight only. Attempting
to tension
the chain
when the chain brake
nuts are tight can
cause damage.
Checking
the tension:
Use the screwdriver
end of the chain adjust-
ment tool (bar tool) to move the chain around
the bar. If the chain does not rotate, it is too
tight. If too loose, the chain will sag below the
bar.
Chain Brake Nuts
Tool (Bar Tool)
Adjusting
the tension:
Chain
tension
is very
important.
Chain
stretches
during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time you
use and refuel your saw.
You can adjust the chain tension by loosen-
ing the chain brake nuts and turning the ad-
justing screw 1/4 of a turn while lifting up on
the bar.
• Ifchain istootight,
turn adjusting screw 1/4
turn counterclockwise.
• If chain is too loose, turn adjusting
screw
1/4 turn clockwise.
Adjusting
_
Screw
/
• Lift up the tip of the bar and tighten the
chain brake nuts securely with the bar tool.
• Recheck chain tension. Tension is correct
when chain does not sag below the bar but
still can be moved around the bar.
WARNING:
If the chain is operated
with a loose chain, the chain could jump off
the guide bar and result in serious injury.
7