Lanaform Excellence Manual De Instrucciones página 6

COMMENTS:
EN
- For your safety, the appliance is provided with an automatic shutdown system after 15 minutes. If you want to continue
your massage, press the On/Off button again (point 1) and then select your massage mode.
- Once your session has ended, the 'Shiatsu' massage mechanism is replaced in its start position, i.e. at the bottom of the
cushion. If the appliance is disconnected before the end of this operation, the mechanism will return to this position
once reconnected. Also don't forget to fold over the headrest on the back before storing it away.
MAINTENANCE
Storage
• Put the "EXCELLENCE® " in its box in a dry place.
• Avoid it coming into contact with sharp edges and other pointed objects which might cut or pierce the fabric surface.
• In order to avoid any breakage of the power lead, do not wind it around the cushion.
• Do not hang the cushion up by the manual control lead or the power lead.
Cleaning
• Disconnect the cushion from the power socket and wait for a few minutes before cleaning it.
• Clean it with a soft, slightly damp sponge.
• Never let water or any other liquid come into contact with the cushion.
• Do not immerse it in liquid to clean it.
• Never use abrasive detergents, brushes or a thinning agent to clean it.
No part of the cushion can be maintained by the user. For any repairs owing to a malfunction, take the appliance to your
reseller who will ensure it is inspected by our after-sales department.
F.A.Q.
BREAkDOWN
The product in not working
Compression massage pressure too
strong or too weak
Noise during use
ADvICE REGARDING THE DISPOSAL OF WASTE
• All the packaging is composed of materials that pose no hazard for the environment and which can be disposed of at
your local sorting centre to be used as secondary raw materials. The cardboard may be disposed of in a paper recycling
bin. The packaging film must be taken to your local sorting and recycling centre.
• When you have finished using the device, please dispose of it in an environmentally friendly way and in accordance with
the law.
6
POSSIBLE CAUSES
The plug is not plugged in correctly
The plug is not connected correctly
The product is not activated
The angle of the seat is not correct
Pressure too strong or too weak
Product adaptation time too short
/
/
REMEDIES
Plug in the flex
Check that the plug is plugged in
correctly
Press the "ON" button
Adjust the angle of the seat
Adjust the power by pressing the
button again for a suitable intensity
Use the product for a while to get
used to it
Normal noise of the gearbox