Lanaform AllergoLux Manual De Instrucciones página 15

2. DIAGRAM AND DESCRIPTION OF
THE PRODUCT
1. Basic appliance
2. Battery compartment
3. Signal light
4. On/off button
5. Cable connector for the nasal applicator
6. Cable
7. End piece for the applicator
8. Nasal applicator
9. LCD display
10. Timer (+ / -)
11. Button for adjusting the intensity (+ / -)
12. Button for choosing the continuous or pulse
mode
2.1 Diagram and description of the LCD
display
a) Continuous mode
b) Operating indicator
c) Pulse mode
d) Intensity
e) Duration of time programmed
f) Low battery
3. ACTIVATION
BATTERY
The AllergoLux appliance operates on 4 alkaline
batteries 1.5 V, type AAA LR03.
Push on the identifying mark on the cover of the
battery compartment (on the back of the appliance)
and push it in the direction indicated by the arrow.
Insert the batteries as indicated. Put the battery compartment cover back on and push it
upward until you hear a click.
4. USING THE ALLERGOLUX APPLIANCE
Connect the nasal applicator cable by inserting the plug in the jack on the AllergoLux
appliance.
Spread the nasal applicator gently and insert the diodes deep into the nostrils.
The appliance should not cause any pain that could bother you; press the "ON/OFF"
button for more than one second to activate the appliance, and choose either the
« continual » or the « pulse » mode.
Then set the timer and the intensity of the light. This appliance turns off automatically
when the time has run out. If you want to interrupt the session, push on the "ON/OFF"
button for more than two seconds to stop the appliance.
/INSERTING THE
�
�
�
��
��
�
�
� �
�
�
�
�
En
�
�
�
��
�
15