Set Up And Operation - Adventuridge ME1-495H-337-G Manual Del Usuario

Twin Airbed With Pump
1. Pull the Latch to unlock the Battery Door. (Fig. 1)
2. Put in four D-size batteries into the battery compartment.
3. The polarity of each battery should be aware of. Place the batteries with the
polarity according to the marking on the battery compartment.
4. Close the Battery Door and use the Latch to lock it properly. (Fig. 2)
5. To Inflate the inflatables:
• Select a flat indoor surface large enough to accommodate the inflatable.
• Remove all sharp and pointy objects on and near this surface.
• Insert the nozzle that fits with the inflatable to the pump inflate outlet. (Fig. 2)
• Lay the inflatable on the surface with the bottom surface attaching the floor.
• Orient the inflatable properly.
• Push the power button to start the pump. (Fig. 2)
• The inflatable will be automatically inflated in about 3 minutes.
• Turn off the pump by pressing the power button again.
6. To quick deflate the product:
• Clean and dry the inflatable. See below "Care, Storage & Maintenance".
• Insert the nozzle to the pump deflate outlet. (Fig. 3)
• Push the power button to start deflating the bed or inflatable. (Fig. 3)
• The inflatable will be deflated automatically in about 3 minutes.
• Once completely deflated, press the power button to stop the pump.
7. Replace ALL four new batteries at once. Do not mix use with old and new batteries to reduce the risk of explosion.
FIG. 2
TO INFLATE
Polygroup Limited (MCO)
888-919-0070
SET UP AND OPERATION INSTRUCTIONS
Power Button
Tel: 86-769-83915520
Nozzle
Latch in locked
position
Battery
Door
FIG. 1
Insert
Batteries
Nozzle
FIG. 3
TO DEFLATE
USA

Set Up And Operation

4x D-size
battery
Latch
Power
Button
4
warranty@polygroup.com