Quantum TURBO 2x2 Instrucciones De Operación página 3

5. CHARGING
Charge at room temperature. Charge the night before, or charge just
before use to be assured of obtaining 100% charge.
Turbo 2x2 is supplied with a universal charger that works with an AC mains
power from 90 to 240 VAC. Your Turbo 2x2 is supplied with one of the fol-
lowing charger models: TRUS (USA, Canada, Japan); TRE (euro coun-
tries); TRUK (United Kingdom); TRA (Australia, New Zealand). Plug
adapters may be used to allow charging from any 90-240 VAC power out-
let. A voltage converter is not necessary.
Be sure the AC mains socket is an uninterruptible line (not switched).
The charge indicator [ ] will light when the charger is properly connect-
ed. It is important not to interrupt the charging so that the computer fuel
gauge remains accurate. If the power is interrupted, the fuel gauge may
read incorrectly for one charge cycle, but will correct itself on the next
cycle.
A full charge takes about 3 hours. For a 1.5 hour full charge time you may
purchase a second charger and connect it to the other socket of the Turbo
2x2. Do not use any other type of charger and risk damage to the
Turbo 2x2 and the charger!
The fuel gauge indicates charging progress as shown in the diagram.
25% charged 50% charged
= steady light
6. "A" and "B" OUTPUT INDICATORS
The indicators "A" and "B" show status of the corresponding outputs.
A steady light means the output is supplying either flash (using
a C Flash Cable) or camera power (using an SD or CD Camera
Cable).
A Blinking indicator shows when high voltage has shut down
(but still supplying low voltage power).
Off indicates no power for that output.
3
75% charged 100% charged
= blinking
= off
Typical examples are shown below:
A and B outputs supplying camera and/or
A B
flash power.
A: supplying camera or flash power;
A B
B: no cord connected.
A: high voltage shut down;
A B
B: supplying camera or flash power
A and B high voltage shut down. Blinking stops
A B
in 30 seconds, then the indicators light steadily.
CD or SD cable will still power a camera.
7. ERROR CONDITIONS and TROUBLESHOOTING
Symptom Solution
A flash or camera cable is The cable could be broken, shorted, or it
connected but the output may be the wrong cable. Connect the
indicator is not lit. cable to the other output; if the output
indicator does not light, the cable has
one of the above problems.
C type Flash Cable is Turbo 2x2 has detected that no flash is
connected to a flash and connected. This could be caused by a
the output light blinks for bad cable or loose cable. Check that the
30 seconds. cable is securely connected and restart
Turbo 2x2.
CD cable is connected to No problem. Turbo 2x2 is testing the
a camera. The output light presence of a flash.
blinks for only 2 seconds
when Turbo is first turned on.
CD Camera Cable connected Probably the "C" Flash Cable has dis-
to one output, C Flash Cable connected from the flash (or the cable is
to the other. Both A and B faulty). The CD cable will still provide
LEDs blink for 30 seconds. camera power, and its indicator will turn
on steadily in 30 seconds.
The fuel gauge's 25% green This is the low battery indication.
light blinks for a few minutes, Recharge. Check that the charger is
and then all lights go out and connected to a live mains outlet that can-
there is no power to the not be switched off.
equipment connected.
4