Installation Instructions - ST Quadrat LUX-top FSE 2003 Guia De Inicio Rapido

Installation Instructions

Rope terminal, self splicing
Exclusively for use with ST Quadrat s.a.
F
The user shall check correct installation in his own responsibility!
ST QUADRAT s.a.
LUX top
50 mm
6-8mm
G
your competenter partner for fall protection systems
®
FSE
stainless steel guide ropes
The screw connection of a cone part (B), three rope
wedges with O ring (C), one brass disc (D)
and one connecting part (E).
IMPORTANT: The end of the rope (A) (approx. 50 mm)
must be absolutely free from oil and grease! Degrease,
if required.
Slide cone part (B) on the rope (A) and align the
rope wedges (C).
Press cone part (B) slightly forward so that the rope
wedges (C) will seize. The rope must
6 8 mm!
Slide on the brass disc!
Screw together the parts with connecting part (E)
tighten by hand!
and
Tighten the screw connection with the fit up aid (F) and
a torque wrench with open ring spanner (G) to the
torque of 50 Nm
required
protrude
!
www.st quadrat.lu