Installation Instructions - ST Quadrat LUX-top G-T Instrucciones De Montaje Y Uso

Installation instructions:

 The installers must ensure that the substructure and the building structure are suitable for
erection of the LUX-top
 The installation area must be thoroughly swept and any dirt removed before erecting the
®
LUX-top G-T (ask the manufacturer for exceptions).
 To protect the roofing membrane, it is recommended to place a protective layer of roofing
membrane identical material underneath the
®
 The LUX-top G-T
manufacturer and in accordance with the assembly, installation and use instructions!
 All connections of the construction must be installed and checked properly and conscientiously
according to the manufacturer's requirements.
 If an all-round parapet wall of at least 150 mm height is not available, a system toeboard
must be installed.
 You must comply with the relevant national regulations and the accident prevention
regulations during assembly and installation of the aluminium guardrail.
 Depending on the working conditions, during erection of the
be protected with additional measures against falling (e.g. by using PPE against falling).
 The installers must take measures to ensure that neither components of the aluminium
collective protection nor tools can fall from the work area.
 On gravel-covered roofs the standing area of the
of gravel. Permanent protection must be ensured while this work is being carried out. After
the collective protection has been fully installed the gravel can be spread around the system
once again.
The LUX-top
natural components of the lightning protection equipment. The components of the
LUX-top
accordance with EN 62305-3
ST QUADRAT Fall Protection S.A. – Your competent partner for fall protection solutions – www.lux-top-absturzsicherungen.de
®
G-T system.
may only be installed using the screws and connectors supplied by the
®
G-T system fulfils the requirements for metal constructions as
®
G-T collective protection are suitable as lightning conductors in
Page 4 Version 05/2019
®
LUX-top G-T (load-bearing variants).
LUX-top
®
LUX-top G-T
®
G-T the workers must
must be thoroughly cleared