Security Lock - Casanoov TOUCH Manual Del Usuario

[Tapez ici]
10.
10. Continuously transmitting 10s
For easy programming the wireless keypad to the receiver or control board, you can make it to transmit the
code continuously for 10s of any of both 2 channels as follow:
a. Enter programming => one long beep follow to confirm
b. Press(55) end up with (# ) => one short beep follow to confirm
c. Key in 2 digits of the channel number which you want it to transmit and end up with (# ). (Example "01#" is
for transmitting the code of 1
d. Keypad exits programming mode.
11.
11. Scrambled pin code
In case you are accompanied by the person who might see the pin code while you key it in, you can scramble
your pin code while you key it in. To prevent the visitors from seeing your pin code.
To key-in a scrambled pin code, you can simply press any digits (0-9) in the keypad.(except the "*" and "# "
keys) as many times as you wish, after you finish the scrambled digits as you wish, then press the correct 4
digits pin code and end up with ( # ) . Keypad would automatically disregard all invalid scrambled digits you
have keyed-in and transmit the correct channel after the ( # ) key is pressed.

12. Security lock

Keypad allows three attempts of wrong entire pin codes. After the third wrong entire pin codes key-in, the
keypad will be locked for 2 minutes with 3 beeps and red LED light goes on. 2 minutes later, keypad would
have one beep sounds and red LED indicator goes off to indicate the user keypad is unlock.
12.
13. Keypad resetting（Required to disassemble the keypad）
When users forget the installer's pin code, you can reset the keypad to factory default setting as follow:
a. Awake the keypad
b. Disassemble the keypad
c. Press the reset button on the board for 5 seconds
d. All led on Keypad turn on to indicate process finished
channel)
st
EN
7