Mellerware Loopy! Path Manual Del Usuario página 11

the adjustment knob by turning it
clockwise.
HOW TO ADJUST THE SEAT
HORIZONTALLY:
Slightly loosen the seat regulator
–
knob (B) by turning it
counterclockwise. Move the saddle
to a comfortable position for
exercising, and then firmly tighten
the knob by turning it clockwise.
HOW TO ADJUST THE
HANDLEBAR:
Position the handlebar (E) at a
–
comfortable distance for exercising
but not going beyond the STOP
mark. Then, tighten the knob firmly.
HOW TO ADJUST THE
HANDLEBAR HORIZONTALLY:
Lose the L knob slightly by turning it
–
anticlockwise. Move the handlebar
to a comfortable position for
exercise and then tight again the
knob securely by turning it clockwise.
Cleaning
For health reasons, it is necessary
–
to clean the handlebars and seat
spray, as well as removing any sweat
from the bicycle's frame. Apply
anti-rust to the flywheel every time
you clean the machine or at least
once a month. Apply oil in the
contact surface of the flywheel with
brake to avoid rattling noises.
Care has been taken to assure
–
that your bike has been properly
adjusted and lubricated at the
factory. It is not recommended that
the user attempt service on the
internal components instead seek
service from an authorized service
center. However, from time-to-time
the outer surfaces may appear dull
or dirty, following the instructions
listed below will restore and preserve
the original finish.
Cleaning metal surfaces may be
–
accomplished by using a soft cotton
or terry cloth rag with a light
application of car wax. Do not
use aerosol sprays or pump
bottles as they may deposit
wax upon the console surface.
From time-to-time, the console
–
surface may collect dust or
fingerprints. The use of harsh
chemicals will destroy the protective
coating and cause a static build-up
that will damage the components.
This surface may be cleaned with
specially prepared chemicals found
in most computer supply stores
especially made for antistatic surfaces.
It is strongly recommended that you
purchase such a cleaning compound.
The safety level of the equipment can
–
only be maintained if it is regularly
examined for damage and/or
wear and tear.
Care must be taken when lifting or
–
moving the equipment so as not to
cause injury.
The brake pad is most susceptible
–
to wear. Before exercising inspect
the braking system for functionality.
EN